Anyone have a picture
Moderator: FORDification
-
fuzzier1
- Preferred User
- Posts: 266
- Joined: Mon Dec 13, 2004 10:48 pm
- Location: New Mexico
Re: Anyone have a picture
That's OK, I am going to build one using 2" x 1/4 square tubing. I hope everyone had a great Thanksgiving.
-
fuzzier1
- Preferred User
- Posts: 266
- Joined: Mon Dec 13, 2004 10:48 pm
- Location: New Mexico
Re:New Question (Anyone have a picture)
New question, what is the measurement inside frame to inside frame at the bottom flange right next to cross member I am missing (riveted in transmission cross member). Also a reference point so I can get the same measurement location. I have temporary bracing on top from when I did my CV install but I need to verify my frame has not splayed out at the bottom before I finish my fab. Thanks again in advance.
Fuzz
Fuzz
-
sargentrs
- 100% FORDified!
- Posts: 9866
- Joined: Fri Jun 22, 2007 9:30 am
- Location: Georgia, Jasper
Re: Anyone have a picture
Can't get to my truck to measure, too much stuff in the way. However, this probably has enough dimensions for you verify what you need to know. http://www.fordification.com/tech/images/bb70/p08.gif
Randy
1970 F100 Sport Custom Limited LWB, 302cid, 3 on the tree. NO A/C, NO P/S, NO P/B. Currently in 1000 pcs while rebuilding. Project thread: http://www.fordification.com/forum/view ... 22&t=59995 Plan: 351w, C4, LSD, pwr front disc, p/s, a/c, bucket seats, new interior and paint.
1987 F-150 XLT Lariat, 5.0/C6 auto.
1970 F100 Sport Custom Limited LWB, 302cid, 3 on the tree. NO A/C, NO P/S, NO P/B. Currently in 1000 pcs while rebuilding. Project thread: http://www.fordification.com/forum/view ... 22&t=59995 Plan: 351w, C4, LSD, pwr front disc, p/s, a/c, bucket seats, new interior and paint.
1987 F-150 XLT Lariat, 5.0/C6 auto.
-
fuzzier1
- Preferred User
- Posts: 266
- Joined: Mon Dec 13, 2004 10:48 pm
- Location: New Mexico
Re: Anyone have a picture
Thanks Sargentrs, I have looked at those but couldn't find what i need.