The 5000.00$ question

No tech discussion, please

Moderator: FORDification

Post Reply
Texarado
New Member
New Member
Posts: 17
Joined: Tue Apr 08, 2014 11:45 am

The 5000.00$ question

Post by Texarado »

I have a 68 SB and I am looking to do some mods on this truck. If you had 5000.00 to spend on any mods what would you guys do? Right now I have a mild cammed 302 with less than 50,00 miles on it. A good c4 and 3.70 rear end gears. The truck went through a resto in the 90's and it has a front end out of a 75 f150 with disc brakes. The body is clean as far as rust goes but needs paint.
User avatar
HIO Silver
100% FORDified!
100% FORDified!
Posts: 1970
Joined: Sat Jul 23, 2011 11:31 pm
Location: Devil's Mountain, CA

Re: The 5000.00$ question

Post by HIO Silver »

AC, PS, PB, and paint.
70 F100 LB 2WD, 360FE, E-Street EFI, TKO-500, 76K original miles.. follow my rebuild: The Lo-Buck Bumpside
71 F250 LB, 2WD, 360FE, T18, PS, PB, D60 with 4.11s
73 F100 SB 4WD, 390FE, NP435, +4 on 35s

01 Ferrari 360 Spider F1
01 F150 SuperCrew Lariat 4WD
01 PT Cruiser Limited (DD)
68 Mustang
65 Mustang
Texarado
New Member
New Member
Posts: 17
Joined: Tue Apr 08, 2014 11:45 am

Re: The 5000.00$ question

Post by Texarado »

PS was part of the 75 150 swap, has A/C and PDB in front with drums in rear. My wish list is to put in an AOD, install coil overs and rear disc brakes with paint.
motzingg
Blue Oval Fan
Blue Oval Fan
Posts: 742
Joined: Wed Apr 24, 2013 1:11 pm
Location: Milwaukee WI

Re: The 5000.00$ question

Post by motzingg »

she-oot!

if i had 5 grand i'd buy another bump, or maybe 4 of them!
User avatar
sargentrs
100% FORDified!
100% FORDified!
Posts: 9866
Joined: Fri Jun 22, 2007 9:30 am
Location: Georgia, Jasper

Re: The 5000.00$ question

Post by sargentrs »

If you're happy with your engine (got headers?) Then a new tranny and a limited slip differential and still have money to spare. I went with the PowerTrax No-Slip.
Randy
1970 F100 Sport Custom Limited LWB, 302cid, 3 on the tree. NO A/C, NO P/S, NO P/B. Currently in 1000 pcs while rebuilding. Project thread: http://www.fordification.com/forum/view ... 22&t=59995 Plan: 351w, C4, LSD, pwr front disc, p/s, a/c, bucket seats, new interior and paint.
1987 F-150 XLT Lariat, 5.0/C6 auto.
ultraranger
Blue Oval Guru
Blue Oval Guru
Posts: 1147
Joined: Wed Apr 27, 2011 9:15 pm
Location: Arkansas, Camden

Re: The 5000.00$ question

Post by ultraranger »

I don't know what the paint job would run you (if you're paying someone else to do the work). If someone else is doing it, it's likely to take most or all of that amount.

Whatever the case, if I had $5,000.00 dollars to spend and needed a paint job, that's what I would spend the money on.

After that, I would add changes as money would allow.

If you add the stuff to it now, the way it presently sits, that's just more stuff that will have to be pulled off before you can strip the truck down, paint, and have to put it all back on again.

If you start with a clean, painted truck, the extras can be added to an already nice rig. Not the other way around.

This is just my opinion of what I would do with the money, if it were mine.
Steve

1969 SWB F100 Ranger. 240-6, C-4, 9" N-case 31-spline Traction-Lok w/3.50 gears.

1968 Mustang. My high school car. Owned since 1982.

2003 Azure Blue Mustang Mach1.
User avatar
72 f100
New Member
New Member
Posts: 59
Joined: Wed Aug 14, 2013 6:15 am
Location: Nokesville Virginia

Re: The 5000.00$ question

Post by 72 f100 »

:hmm: :hmm: ifs, posi, relocate the gas tank under the bed, bucket seats with a center console. :D
User avatar
Heirloom
Blue Oval Fan
Blue Oval Fan
Posts: 549
Joined: Fri Feb 08, 2013 2:33 pm
Location: Paradise

Re: The 5000.00$ question

Post by Heirloom »

Posi, overdrive trans and paint.
~Heirloom

'68 F250 360, 4 spd Project Thread!
Plans are for a stout 400, C6, 3.54 gears, 33" BFG AT's, bucket seats and custom console. Final assembly, nearing start up...


"Those who hammer their guns into plows will plow for those who do not."
~ Thomas Jefferson

"America will never be destroyed from the outside. If we falter and lose our freedoms, it will be because we destroyed ourselves."
~ Abraham Lincoln
User avatar
BobbyFord
100% FORDified!
100% FORDified!
Posts: 5372
Joined: Sun Feb 04, 2007 9:52 am
Location: Chatsworth, California

Re: The 5000.00$ question

Post by BobbyFord »

Paint
User avatar
HIO Silver
100% FORDified!
100% FORDified!
Posts: 1970
Joined: Sat Jul 23, 2011 11:31 pm
Location: Devil's Mountain, CA

Re: The 5000.00$ question

Post by HIO Silver »

Nice paint is over-rated.

Visually....

Image Image
User avatar
DuckRyder
Moderator
Moderator
Posts: 4925
Joined: Mon Jul 19, 2004 3:04 pm
Location: Scruffy City
Contact:

Re: The 5000.00$ question

Post by DuckRyder »

Unless the body is nearly perfect I doubt 5000.00 will get a really quality paint job.

Should do fuel injection and an AOD swap...
Robert
1972 F100 Ranger XLT (445/C6/9” 3.50 Truetrac)

"An unarmed man can only flee from evil, and evil is not overcome by fleeing from it." -- Jeff Cooper
User avatar
BobbyFord
100% FORDified!
100% FORDified!
Posts: 5372
Joined: Sun Feb 04, 2007 9:52 am
Location: Chatsworth, California

Re: The 5000.00$ question

Post by BobbyFord »

Good bodywork and paint is all about connections :D
User avatar
BrockGrimes
New Member
New Member
Posts: 171
Joined: Tue Jan 07, 2014 5:33 pm
Location: Georgia, Warner Robins

Re: The 5000.00$ question

Post by BrockGrimes »

I'd swap in a TBI setup from "Afforadable fuel injection" and a 4r70w.
If it's not broke, MOD IT!

1972 F100 short wheel base, 302, C6, 9"
Texarado
New Member
New Member
Posts: 17
Joined: Tue Apr 08, 2014 11:45 am

Re: The 5000.00$ question

Post by Texarado »

Thanks for the replies. I've got hooker headers on the 302 now. I like the idea of fuel injection. I seriously doubt I will be throwing a high quality paint job on the truck. I still have to use it for hauling every now and then. The IFS idea is also great but I don't really have the skills to make that swap with all the welding and fab work that would have to be done. I can turn a wrench but I've never done any fab work. The AOD swap and paint is gonna happen just not sure what else yet. I might have to bump up my 5000.00 to 7000. 00!
Texarado
New Member
New Member
Posts: 17
Joined: Tue Apr 08, 2014 11:45 am

Re: The 5000.00$ question

Post by Texarado »

So it's been awhile since I've been on the site, mainly because I've been really busy with all the mods on the 68. So far I have installed an AOD tranny which I got from salvage yard for 300$ and spent another 1000$ having it completely rebuilt with a stage 2 kit which is suppose to be good for 450hp. My truck don't make no where near that but I was thinking for the future. I also installed a DJM I beam 3" drop kit in front and a 6" kit in back also from DJM which cost about 700$ While I was doing the kit up front I went ahead and replaced the king pins, tie rod ends, drag link bar, and shocks. While doing the kit in the rear I also installed all new bushings for leaf springs and shackle, new shocks, axle bearings and installed MB products disc brake conversion. All of that was appro. 700$
So the truck is pretty tight at this point.
After that was all done I decided to do a bucket seat conversion and put in a console. I have since moved the shifter from the column to the floor using a lokar kit and I'm loving it.
More to come if any one is interested!!
Post Reply